another angle,they need to be ''bore''not drill,to keep the concentricity
the bar inside diameter is ''rifle' so they need to be machine before the bar ends can be install,difficult and very elaborate is not but a big machine need it,pain in the butt
four side totem
this is the programing console, you can just insert a disc if is all pre0program,,sound easy IS NOT...
fixtures to hold the pieces
I polish each of them by hand ,,thanks to TODD for the use of his scoth guard polishing wleel
the quality oof the surface is already great but with this becomes really satin, no tool marks are leftis a lot of work
is a lot of work about 5 mintues each piece if you multiplied by 300 is a very long time.
I do it my self to keep the cost down,and to make sure is done right too.
only a hundred and twenty four to go
do the look pretty or what????
one box for each color.I don't have a car so I only transport a finete amount of units each time, no biggy the anodize shop is only 20 millles away
mountains ,valleay,smountains, you get the idea
control flat tablle,I dont really need it, but is a good place for pictures
this shop is very serius, they have a ton of equipment and best of all they know how to use it......
I have those two problems...
bar ends 007
bar ends 015
bar ends 016
bar ends 017
bar ends 009
bar ends 012
Avatar mini foto
Bars At House 001
Bars At House 002
Bars At House 003
Bars At House 004
Bars At House 005
Bars At House 006
Bars At House 007
Bars At House 008